installing carpet pad::This procedure should be done carefully to avoid cutting holes in the wrong place installing carpet pad

installing carpet pad

installing carpet pad

installing carpet pad::This procedure should be done carefully to avoid cutting holes in the wrong place.
When cutting or trimming, always make minimal cuts.
You can always make a second cut, but you can not undo a cut once it has been made.
It is best to wait until the very end to trim around the edges of your new carpet.
Lay carpet flat outside the vehicle.
It is best to wait until the very end to trim around the edges of your new carpet.
Repeat steps 3, 4 and 5 if a second shift lever exist after the full installation of your carpet is complete, return to the shift levers and cut the holes larger.
After correct fit is determined, fold back sections of the carpet.
Apply adhesive then smooth down and press into position on some carpets you will find slight excess of material on both sides at the sill plates and around the edges.
This is purposely included to provide for possible variations of individual installations.
Replace accelerator pedal, and smooth out carpet so that it lies flat.
Replace sill plate and screws slit to edge of carpet under valance, if your vehicle has one note: some models will require hole openings for steer post pedals, mounting brackets, etc.
These holes should be cut carefully after verifying that carpet fits properly
installing carpet pad::During this process, carpet padding tends to get
overlooked or treated as an installing carpet pad